
SMS 07+ NF
Compact multiswitch series
with Energy Saving Technology



SPAUN multiswitches – satellite reception for the whole building
A multiswitch distributes the signal of a single satellite dish to many outlets. Every flat and every room gets the full range of channels, without its own dish and without compromising picture quality. The SMS 07+ series from SPAUN covers everything from the two-family house to a residential block with 16 outlets.
What sets the SMS 07+ series apart
- Typically 0.1 watt at rest – the satellite IF amplifiers and the LNB remote supply only run while at least one receiver is in use. Over the years this is the difference you notice most against a distributor that runs around the clock
- Power supply already built in – short-circuit proof switch mode supply for 90–240 V and 47–63 Hz, no extra unit in the distribution cabinet
- Strength for the LNB – up to 500 mA remote supply current feeds even a Quattro LNB at the end of a long cable run reliably
- Aerial and return path included – the terrestrial input is passive and return path capable, so DVB-T is easy to feed in as well
- Developed and manufactured in Germany – design, production and technical support come from one source
Which size do I need?
What counts are outlets, not rooms: every receiver tuner occupies one output. A twin-tuner receiver that records one channel while showing another therefore needs two of them. Allow for some spare capacity and an output stays free when another device is added later.
- SMS 51607+ NF – 1 satellite, 16 subscribers
- SMS 51207+ NF – 1 satellite, 12 subscribers
- SMS 5807+ NF – 1 satellite, 8 subscribers
- SMS 5607+ NF – 1 satellite, 6 subscribers
- SMS 9807+ NF – 2 satellites, 8 subscribers, for two Quattro LNBs
Which LNB goes with it?
A Quattro LNB is the recommended choice: it delivers all four reception bands permanently and simultaneously to the multiswitch, which then only has to distribute them. On the single-satellite models the built-in 22 kHz generator also allows a Quad LNB to be used. Make sure the input levels of the bands arrive at a similar strength – that is the basis for a clean picture at every outlet.
You will find all models together in the Multiswitch category.